Hawking HW9ACM User Manual page 108

Beacon Interval(3):
DTIM Period(4):
Data Rate(5):
N Data Rate(6):
Channel Width(7):
Preamble Type(8):
Broadcast ESSID(9):
CTS Protect(10):
Transmit Power(11):
Set the beacon interval of wireless radio. Do not modify the
default value if you do not understand the function, default
value is '100'.
Set the DTIM period of wireless radio. Do not modify the
default value if you do not understand the function, default
value is '3'.
Set the wireless data transfer rate to a certain value. Since most
of wireless devices will negotiate with each other and pick a
proper data transfer rate automatically. It is not necessary to
change this value unless you know what will happen after
modification.
Same as above, but only for 802.11n clients.
Set channel width of wireless radio. Do not modify the default
value if you do not understand the function, default 2.4GHz
setting is 'Auto 20/40 MHz' and the default 5GHz setting is
'20/40/80MHz'
Set the type of preamble, do not modify the default value if you
do not know what it is, default setting is 'Short Preamble'.
Decide if the wireless access point will broadcast its own ESSID
or not. You can hide the ESSID of your wireless access point (set
the option to 'Disable'), so only those people who know the
ESSID of your wireless access point can connect to the unit.
Enabling this setting will reduce the chance of radio signal
collisions between 802.11b and 802.11g/n wireless access points.
It is recommended to set this option to 'Auto' or 'Always'.
However, if you set to 'None', your wireless access point should
be able to function properly.
You can set the output power of wireless radio. Unless you are
101