Power Hitch™ System Instructions - Blizzard 680LT Installation Instructions & Owner's Manual

Prior to operating your straight blade snowplow, review
the Mounting and Dismounting Instructions label on
the back of the driver-side moldboard.
MOUNT INSTRUCTIONS
Read Owner's Manual for Complete Instructions.
STEP #1
CONNECT/DISCONNECT
POWER HITCH Switch
Pushbeam
Receiver
Mount Points
Kickstand Pin
Adjustable
A-Frame
Kickstand
Mount Bushing
• Kickstand must be lowered, with kickstand pin seated in lower hole on pivot beam.
• Slowly drive vehicle forward until pushbeam receiver mount points contact
A-frame mount bushings.
• Turn POWER HITCH OPERATION switch (on plow control) to "ON" position.
• Connect plow and vehicle electrical harnesses. Connect weather caps together.
STEP #2
A-Frame
Latch
Lock Pin
A-Frame Latch
rotates clockwise
and hooks onto
Draw Pin
• Pull A-frame latch lock pin out and lower A-frame latch over draw pin.
• Push and hold CONNECT/DISCONNECT switch upward. POWER HITCH arm
will engage back of pushbeam and pull plow into pushbeam receiver mount
points on vehicle.
• Insert both hitch pins and secure each with hair pin cotter.
• Lower POWER HITCH arm to relieve tension on A-frame latch. Raise A-frame
latch and lock into position with lock pin. Raise plow.
• Raise kickstand until kickstand pin seats into upper hole on pivot beam.
U.S. Patents 5,638,618; 5,899,007; 6,178,669; 6,276,076; 6,393,737; 6,408,549; 6,412,199; 6,442,877; 6,615,513; Canadian and other patents pending.
Lit. No. B64118, Rev. 03
POWER HITCH™ SYSTEM INSTRUCTIONS
Undercarriage
Pushbeam
Slowly Move
Vehicle Forward
POWER
HITCH Arm
WARNING: Keep fingers away. POWER HITCH arm raises behind undercarriage pushbeam.
A-Frame
Hitch
Latch
Pin
Draw
Pin
NOTE: If at any time the Mounting and
Dismounting Instructions label, or any other label
attached to your snowplow becomes illegible,
promptly replace them.
DISMOUNT INSTRUCTIONS
Read Owner's Manual for Complete Instructions.
CONNECT/DISCONNECT
POWER HITCH Switch
Kickstand Pin
• Raise plow. Lower kickstand until kickstand pin is seated in lower hole on pivot beam.
• Lower plow on flat, level surface. Turn vehicle ignition off.
• Remove hitch pins from A-frame and undercarriage.
• Turn vehicle ignition on.
• Turn POWER HITCH OPERATION switch (on plow control) to "ON" position.
CONNECT/DISCONNECT
POWER HITCH Switch
Kickstand Pin
Adjustable
Kickstand
WARNING: Keep fingers away from plow and truck mounting points.
• Push and hold CONNECT/DISCONNECT switch downward. POWER HITCH
arm will disengage from behind undercarriage pushbeam and lower.
• Disconnect plow and vehicle electrical harnesses. Install weather caps.
• Turn SYSTEM POWER (on plow control) to "OFF" position.
• Slowly move vehicle backward away from plow.
30
STEP #1
Hitch
Pin
Adjustable
Kickstand
POWER
HITCH Arm
STEP #2
Slowly
Move Vehicle
Backward
POWER HITCH Arm
March 1, 2009
44812