Table of Contents
Advertisement
Quick Links
Blizzard, PO Box 245038, Milwaukee, WI 53224-9538 • www.blizzardplows.com
UNDERCARRIAGE KIT
Ford Super Duty F-250/350/450/550 2008 - 10
30269
Installation Instructions
CAUTION
Read this document before installing the
snowplow.
CAUTION
See your BLIZZARD
outlet/Web site for
®
specifi c vehicle application recommendations
before installation. The Undercarriage
Selection Guide has specifi c vehicle and
snowplow requirements.
A DIVISION OF DOUGLAS DYNAMICS, L.L.C.
March 15, 2010
Lit. No. 69656, Rev. 03
Advertisement
Table of Contents
Related Manuals for Blizzard 30269
Summary of Contents for Blizzard 30269
- Page 1 Blizzard, PO Box 245038, Milwaukee, WI 53224-9538 • www.blizzardplows.com March 15, 2010 Lit. No. 69656, Rev. 03 30269 UNDERCARRIAGE KIT Ford Super Duty F-250/350/450/550 2008 - 10 Installation Instructions CAUTION Read this document before installing the snowplow. CAUTION See your BLIZZARD outlet/Web site for ®...
-
Page 2: Safety Definitions
SAFETY SAFETY DEFINITIONS WARNING/CAUTION & INSTRUCTION LABELS WARNING Become familiar with and inform users about the Indicates a potentially hazardous situation warning and instruction labels on the back of the that, if not avoided, could result in death or blade. serious personal injury. -
Page 3: Safety Precautions
SAFETY SAFETY PRECAUTIONS PERSONAL SAFETY Improper installation and operation could cause • Remove ignition key and put the vehicle in park or personal injury and/or equipment and property damage. in gear to prevent others from starting the vehicle Read and understand labels and the Owner's Manual during installation or service. -
Page 4: Torque Specifications
TORQUE SPECIFICATIONS TORQUE CHART CAUTION Read instructions before assembling. Fasteners should be fi nger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment. Grade Identifi cation for J429–Grade 5 Bolt Grade Identifi... -
Page 5: Installation Instructions
UNDERCARRIAGE INSTALLATION INSTALLATION INSTRUCTIONS 5. Place a spacer inside the passenger's side of the truck frame with the slots closest to the center of the vehicle. Insert a 7/16" x 2-1/2" cap screw NOTE: For easier assembly and installation, vehicle down through a 7/16"... - Page 6 UNDERCARRIAGE INSTALLATION 22. Fully tighten rear bracket fasteners according to CAUTION the torque chart. Diesel equipped vehicles must use supplied 1/2" x 1-1/4" cap screws between frame and 23. Make sure the mounts are tight up against the intercooler to prevent intercooler damage truck frame.
- Page 7 UNDERCARRIAGE INSTALLATION 26. Tighten the cable tie until it is snug, taking care 28. Reattach the bumper with original fasteners. not to crimp tubing. Trim excess length. 29. If the air dam does not clear the U-brackets, notch as needed. 30.
- Page 8 MOUNT ADAPTER INSTALLATION MOUNT ADAPTER INSTALLATION Install adapter plates as follows: 1. Position the adapter plate against the driver's side portion of the mount adapter as shown. Insert a 3/4" x 2-3/4" cap screw through the lower front adapter plate hole and through the appropriate hole on the mount adapter.
- Page 9 Lit. No. 69656, Rev. 03 March 15, 2010...
- Page 10 Blizzard or the vehicle manufacturer may require or recommend optional equipment for snow removal. Do not exceed vehicle ratings with a snowplow. Blizzard offers a limited warranty for all snowplows and accessories.