Blizzard 680LT Installation Instructions & Owner's Manual page 25

ELECTRICAL INSTALLATION – VEHICLE SIDE
NOTE: The red power wire MUST be fused and
switched ON and OFF with ignition.
Secure all loose wires under the dash.
13. Install the light tower. Position the arms into the
receiving pockets located on the undercarriage.
Each pocket has a lock pin that secures both light
tower arms. Pull out and twist each handle to
temporarily unlock the pins. Place the light tower
into the pockets and re-lock the pins. See your
local BLIZZARD dealer for complete installation
®
instructions for your vehicle undercarriage.
14. Install the snowplow headlamps. Align one
headlamp stud on the light tower tube with the
mounting hole and insert the threaded stud
through each. Secure the headlamp with one
1/2" galvanized washer (neoprene facing up), one
7/16" external tooth lock washer and locknut.
NOTE: All snowplows are shipped with two caps
that install on the ends of the light tower.
After adding a liberal amount of dielectric grease,
connect the terminals from the snowplow
headlamps to the terminals on the main lighting
harness.
15. If using a joystick control, align the mount holes
on the joystick control with the holes located on
the mount pedestal.
NOTE: The radius on the pedestal should face the
dashboard.
Secure the joystick to the pedestal with the
8 x 3/4" machine screws provided. Slide the
hook-and-loop fastener strap through the slots
cut in the pedestal. The D-ring should be located
on the side opposite of the radius. Wrap the strap
around the bench and fasten.
16. Connect the white power connector from the
vehicle wire harness to the connector on the
control station. The power switch should be in the
"OFF" position.
Lit. No. B64118, Rev. 03
NOTE: The operation of the draw latch can only
be controlled when the switch on the control
is in the "POWER HITCH™" position and the
"RAISE/LOWER" rocker switch on the A-frame is
in the neutral (center) position.
17. After completing the mechanical and electrical
installations, test all snowplow and lighting
functions before attempting to drive or plow.
Joystick Control
Touchpad Control
25 March 1, 2009