Operating System And Drivers; Standard Raspbian Operating System; Installation; Emview-7/Rpi3 Driver Installation Script - Janz Tec emVIEW-7/RPI3 Hardware Manual

emVIEW-7/RPI3 (Hardware and Software Manual) • Operating System and Drivers
5

Operating System and Drivers

When you order the emVIEW-7/RPI3 with pre-installed software (Raspbian operating system), then
our default Janz Tec image is pre-installed on the µSD-card and the emVIEW-7/RPI3 driver package
is already installed and fully configured. For more information, refer to 5.2.
Of course, you can order the emVIEW-7/RPI3 without software, so you can choose a Raspberry PI 3
B compatible operating system of your choice and install it manually on a µSD card. (Raspbian
recommended)
Refer to 5.1.1 on how to install an image from the official Raspberry Pi website.
5.1

Standard Raspbian Operating System

If the additional interfaces of the emVIEW-7/RPI3 (RTC, CAN and RS232/RS485) are not required,
then the latest official Raspbian operating system is recommend for emVIEW-7/RPI3 systems. (Digital
IO and LEDs are controllable by standard GPIO commands and console (RS232) is supported by
Raspbian by default). To use all the emVIEW-7/RPI3 features, refer to chapter 5.2 and 5.3.
5.1.1

Installation

For more information on how to prepare a µSD-card to run the Raspbian operating system visit:
https://www.raspberrypi.org/documentation/installation/installing-images/README.md
Our Janz Tec image is based on the official RASPBIAN JESSIE LITE image from 2016-09-23 with
Kernel 4.4.
(SHA-1: 3a34e7b05e1e6e9042294b29065144748625bea8)
Download at: https://downloads.raspberrypi.org/raspbian_lite/images/
Default log in credentials:
Username: pi
Password: raspberry
(depending on your keyboard layout language, the last "y" might be "z" on your keyboard)
For more information visit the official Raspberry quick start guide:
https://www.raspberrypi.org/help/quick-start-guide/
5.2

emVIEW-7/RPI3 Driver Installation Script

NOTICE
Always create a backup of the µSD card before installing this script!
NOTICE
This script is only compatible to Raspbian based installations!
Rev. 1.0
raspbian_lite-2016-09-28/
© Janz Tec AG
5 - 19