Installation; Mounting - Janz Tec emVIEW-7/RPI3 Hardware Manual

emVIEW-7/RPI3 (Hardware and Software Manual) • Installation
3

Installation

WARNING: Burns Hazard
The product generates considerable amount of heat. The housing transports this heat to
the environment and therefore gets hot. Caution when touching the housing, burns
hazard!
The product can be operated with DC power supply from 10 to 32 V.
3.1

Mounting

The emVIEW-7/RPI3 is intended for installation into a panel, but can as well be mounted on a 35mm
DIN-rail.
Do not block heat
transfer below and
above the housing
figure 2: emVIEW-7/RPI3 mounting options: DIN Rail or panel mount
Rev. 1.0
Top
Fix with
M3 washer
and nut
Do not block heat
transfer below and
above the housing
Top
© Janz Tec AG
3 - 9