Playing A Cd - Pioneer PDR-W739 Operating Instructions Manual

4 Getting Started
Î
DISC 1 DISC 2 3 CD-R
DISC
& * #
! ⁄ $ ›
1 2 3
4 5 6
7 8 9
10/0 >10
COMPACT DISC RECORDER/
MULTI-CD CHANGER
REMOTE CONTROL UNIT

Playing a CD

This section takes you through using the basic playback controls of
the CD changer and CD-R. The steps below describe playing a disc
in tray 1 of the disc changer, but the playback controls for the CD-R
and for other discs loaded into the changer work in exactly the
same way.
1 If the recorder isn't already on, press
POWER to switch on.
The display lights up.
2 Press OPEN/CLOSE 10 (front panel
only) to eject the CD changer disc
tray.
• To open the CD-R tray, press
right-hand side of the unit.
Place a CD, with the label face up, on to the disc tray,
making sure that it is seated properly in the disc guide.
Note: Do not use an adapter when playing 8cm CD-
singles. The disc tray has guides for both 12cm and 8cm
discs.
3 Press OPEN/CLOSE 10 again to
close the disc tray.
4 Press DISC 1 (CD SELECT 1 on the
front panel) to start playback.
• For CD-R playback, press
(6 on the front panel).
To pause playback, press 8 (6 on
5
the front panel).
To resume playback, press again.
14
COMPACT DISC RECORDER / MULTI-CD CHANGER
OPEN/CLOSE
0
1
3
- COMPACT DISC MULTI CHANGER
0
2
0
3
3-CD CONTROL
4 1 ¡ ¢
POWER
6 7
— OFF _ ON
3-CD changer controls
0 on the
/
OPEN CLOSE
- on the remote control
CD R
◊ÛB¿ˆ≥≤/
CD SELECT
1
2
3
6 To fast-reverse or fast-forward, press
and hold 1 or ¡ (41 or
¡¢ on the front panel).
Release to resume normal playback.
If you reach the end of the disc while pressing ¡
(¡ ¢), the display shows
into play-pause mode (you can still reverse-search).
7 To skip back or forward to another
track, press 4 or ¢ (4 1 or
¡¢ on the front panel).
Pressing ¢ (¡ ¢) once skips to the start of the
next track on the disc. Further presses take you to
subsequent tracks.
Pressing 4 (4 1) once takes you to the beginning
of the current track. Further presses skip to the start of
previous tracks.
You can use the track skip buttons while the disc is paused
or stopped, too. The track number changes while the disc
remains paused/stopped.
8 To skip directly to another track, press
the corresponding number button.
• For track numbers 1 to 10, use the corresponding number.
• For track numbers over 10, press the >10 button, then enter
the track number. For example, to select track 20 press >10,
2, then 10/0.
To stop playback, press 7.
9
If the disc was paused, then the pause mode is canceled.
Remove the disc from the recorder before switching off.
COMPACT DISC DIGITAL RECORDER
CD-R CONTROL
4 1 ¡ ¢
6 7
CD-R controls
and the recorder goes
END
OPEN/CLOSE
0