Derigging - DG Flugzeugbau DG-1000 Flight Manual

Flight manual DG-1000S
Ballast box in the fin cont.
In addition with TN413/4 executed, standard from ser. no. 10-49 on:
A switch will be operated by the locking pin of the ballast box cover. As long as
the switch is not closed, the control light for the ballast box will blink with
doubled speed without interruption. The blinking can't be switched off by
pressing on the control light contrary to the blinking which indicates the amount
of ballast.
4.2.5

Derigging

Derigging follows the reverse of rigging.
Waterballast must be dumped first.
Lock the airbrakes.
For disassembling the securing pins of the wings the tool W 38/2 must be
screwed into the thread completely.
The brass part of the tool will then disengage the securing of this bolt.
It is recommended to leave the securing pin in the right wing while you derig the
left wing.
Derigging of the outboard wing panels (20m wing extensions or 18 m or 17,2 m
wing tips):
Use a 6 mm diameter pin (e.g. tool W36) for pressing in the locking pin on the
wings upper side. Pull out the wing tip or the wing extension.
Appr.
Issued: February 2016 TN1000/25 4.6