Utilitech 7115-02 Installation Manual page 7

NEW CONSTRUCTION ASSEMBLY INSTRUCTIONS
4. Mount the fan housing (A) to the joist or stud using
wood screws (4.1) (not included) where indicated.
5. Pull the house wires through the wire box cover hole.
Using a quick connector, secure 120 V AC house wiring
from the wall switch to the fan as shown in the wiring
diagram on page 5. 14 AWG is the smallest conductor
that should be used for branch-circuit wiring.
Carefully push the connected wires back into the
wiring box housing. Reattach the wiring box cover.
CAUTION: If the electrical wires do not match the
colors listed, you must determine what each house
wire represents before connecting. You may need to
consult an electrical contractor to determine safely.
6. Install a circular 4 in. duct (6.1) (not included) and
secure it with duct tape or clamps (neither included).
Finish ceiling work. The ceiling hole should be aligned
with the edge of the fan housing (A).
4
4.1
5
A
6
4 in. duct
7
A
Joist or
wall stud
4.1
A
6.1
Duct tape
or clamp
Ceiling