Advertisement
Installation
This section shows you how to install the Utility if you are using Windows 2000, 98, ME, or NT operating systems.
Follow the instructions given below on how to install the hardware (WUS-B12 USB Adapter) and then the
software (driver and utility). For those using Windows XP, the installation procedure will be the same until the
utility installation. Windows XP has a built in utility for wireless devices. The configuration utility does not need to
be installed for users using the XP operating system.
System Requirements:
•
A laptop computer with an available USB port
•
At least a 300 MHz processor and 32 MB of memory
•
USB Controller properly installed and working
•
An 802.11b Access Point (for Infrastructure Mode) or another 802.11b wireless adapter (for Ad-Hoc
mode.)
1. Installing the WUS-B12
•
Turn on the computer
•
Insert the WUS-B12
Wireless USB Adapter
2.
Installing the Driver
Installing the software involves two steps. The first is to install the Driver and the second is to install the
Configuration Utility.
•
When the WUS-B12 has been inserted into the USB port, the Found New Hardware Wizard screen
appears.
14
Advertisement
