Table of Contents
Advertisement
2. Installation
2
I nstallation
The chapter is about the installation of the device and connecting to other
appliances, presenting also the mounting options and further assembly steps:
Mounting Options
Ý
Connecting Steps
Ý
DA2DVI-HDCP-Pro – User's Manual
2.1. Mounting Options
To mount the distribution amplifier Lightware supplies an optional
accessory 1U high rack shelf. The device has two mounting holes
with inner thread on the bottom side. Fasten the device by the screws
enclosed to the accessory.
WARNING! Always use the supplied screws. Using different (e.g.
longer) ones may cause damage to the device.
D D A A 2 2 D D V V I I - - H H D D C C P P - - P P r r o o
SOURCE
SIGNAL
HDCP
MONITOR 1
MONITOR 2
EDID
PRESS
+5V
PRESENT
ACTIVE
HOTPLUG
HOTPLUG
STATUS
LEARN
POWER
00: EDID COPY
USB
FROM OUT 1
CONTROL
2 OUTPUT HDCP AND HDMI1.3 COMPLIANT DISTRIBUTION AMPLIFIER
Mounting with 1U-high Rack Shelf
1U-high rack shelf provides mounting holes for fastening four quarter-
rack sized units. To order mounting accessories please contact
sales@lightware.eu.
INFO: The distribution amplifier is quarter-rack sized.
2.2. Connecting Steps
PC
Monitor
DVI
DVI
D D A A 2 2 D D V V I I - - H H D D C C P P - - P P r r o o
SOURCE
SIGNAL
HDCP
MONITOR 1
MONITOR 2
EDID
PRESS
+5V
PRESENT
ACTIVE
HOTPLUG
HOTPLUG
STATUS
LEARN
POWER
00: EDID COPY
USB
FROM OUT 1
CONTROL
2 OUTPUT HDCP AND HDMI1.3 COMPLIANT DISTRIBUTION AMPLIFIER
Power
USB
Power adaptor
Connect the source device (e.g. a PC) to the distribution
amplifier's input port by a DVI cable.
Connect the sink device(s) to the distribution amplifier's
output port(s) by a DVI cable.
Optionally connect the amplifier to a controller device (e.g.
USB
a laptop) by a USB cable.
Firstly connect the power adaptor to the DC input on the
device, then to the AC power socket.
7
Projector
DVI
DA2DVI-HDCP-Pro
Laptop
Advertisement
Table of Contents
