Operating Notes and Restrictions
Autorun is enabled by default, until passwords are set on the device.
■
■
Secure-mode and encryption-key are disabled by default.
■
To enable secure mode both an encryption key and trusted certificate
must be set.
If secure-mode is enabled, the following conditions apply:
■
•
the encryption-key cannot be removed/un-configured;
•
the key-pair cannot be removed.
If secure mode is disabled, the key-pair can be removed using the crypto
■
key zeorize autorun command.
When installing the autorun certificate file and/or the other key files, the
■
files must be in PEM format.
Autorun and Configuring Passwords
When an operator or manager password is configured on a switch, autorun
will be disabled automatically, and a message is displayed on the screen as
shown in the following example:
ProCurve# password manager
New password for manager: *****
Please retype new password for manager: *****
Autorun is disabled as operator/manager is configured.
After passwords are set, autorun can be re-enabled as needed using the autorun
command.
For more information on configuring passwords, refer to the chapter on
"Username and Password Security" in the Access Security Guide for your
switch.
File Transfers
Using USB Autorun
A-41