Fault/Error Codes - Amana L-90 Service Manual

DIAGNOSTICS & TROUBLESHOOTING

Fault/Error Codes

Display
EA
E1
E2
E3
EC
E4
EL
2-4 Amana Compact Washer
n
For Service Technician Use Only
(The fault codes below may be indicated under various conditions.)
Explanation and Recommended Procedure
Pressure (Water Level) Sensor
The washer will beep and this error code will appear when the water level reaches
approximately 3/4" (18 mm) below the overflow point for 3 seconds. It will then pause, drain
the water to the highest load size level, then turn off the pump. The lid will remain locked.
See TEST #3: Pressure Sensor on page 3-7.
Low/No Water Fill
This error code will appear if the water level in the washer does not reach the lowest level
within 10 minutes or the set level within 20 minutes of starting a cycle.
See TEST #2: Water Valves on page 3-6.
See TEST #3: Pressure Sensor on page 3-7.
Abnormal Drain
This error code will appear if the washer fails to reach the reset level after draining the water.
See TEST #5: Drain Pump on page 3-9.
See TEST #3: Pressure Sensor on page 3-7.
Abnormal Spin
This error code will appear if the tub strikes the tub switch several times without balancing
itself. In a spin only cycle, the error code will appear the first time the tub strikes the tub
switch.
See TEST #7: Out of Balance Switch on page 3-14.
Abnormal Load Weight Detected
This error code will appear if the motor rotates without water in the tub.
Lid Open
This error code will appear if the washer lid remains open after starting a cycle.
See TEST #8: Lid Lock Assembly on page 3-15.
Lid Lock Malfunction
This error code will appear if the washer makes 5 unsuccessful attempts to lock the lid.
See TEST #8: Lid Lock Assembly on page 3-15.