Manual Load Test Chart - Amana L-90 Service Manual

Manual Test Mode
Spin Test
Press POWER to turn on the washer.
Press and hold "+" while pressing START three times. A tone
will sound for 1 second to indicate successful entering of the
Spin Test.
The display will indicate "3" if there is no water in the tub,
"4" if there is water in the tub. The "Normal" indicator will be
flashing. When water in the tub reaches the "RESET" level,
the washer will start to spin (continuous for 1 minute, off for 1
minute). The washer will then turn off.
If the lid is opened during the spin, the display will indicate
"E4" and the washer will stop spinning. If the lid is closed
again, the washer will resume spinning. If the tub switch
detects an unbalance during the spin, "E3" will show on the
display and the motor will stop.
Press POWER to clear the error and exit the test.
Lid Switch Test
Press POWER to turn on the washer.
Press and hold CYCLE while pressing START three times. A tone
will sound for 1 second to indicate successful entering of the
Lid Switch Test.
The "Normal" indicator will be lit, and the washer tub will
begin to rotate clockwise. If the lid is opened, the tub will stop;
if it is closed again, the tub will resume rotation. The tub will
not rotate if it contains water.
Press POWER to exit the test.

Manual Load Test Chart

Press CYCLE Until Following Indicator is Lit:
Normal
Delicate
Heavy Duty
Rinse
Spin
Clean Washer
Press POWER to exit the test.
For Service Technician Use Only
Press and Hold START to Initiate:
Clockwise rotation of the motor
Counter-clockwise rotation of the motor
Activation of the Drain Pump
Activation of the Cold Water Valve
Activation of the Hot Water Valve
Activation of the lid lock solenoid (lid
will lock) (Release of START will unlock
DIAGNOSTICS & TROUBLESHOOTING
UI/LED Test
Press POWER to turn on the washer.
Press and hold LOAD while pressing START three times. A tone
will sound for 1 second to indicate successful entering of the
UI/LED Test. The display will indicate "8.8." and all indicators
will be off.
Press "–". The Control Lock and Lid Lock indicators will be lit.
Press "–" again. The Control Lock and Lid Lock indicators will
turn off.
Press CYCLE. All of the Cycle indicators will be lit. Press CYCLE
again. The Cycle indicators will turn off.
Press "+". The 7-segment display showing "8.8." will turn off.
Press "+" again. The 7-segment display will turn on.
Press LOAD. All of the Load indicators will be lit. Press LOAD
again. The Load indicators will turn off.
Press TEMP. All of the Temp indicators will be lit. Press TEMP
again. The Temp indicators will turn off.
Press POWER to exit the test.
Manual Load Test
Refer to "Manual Load Test Chart" below.
NOTE: The tub must be empty of clothes and water before
running this test.
To activate Manual Load Test, press and hold CYCLE and turn
on the washer. While continuing to press and hold CYCLE,
press START three times. A tone will sound for 1 second to
indicate successful entering of the Manual Load Test. The
"Control Lock" indicator will be lit.
Instructions: Press CYCLE to select the Load to test. Press
and hold START to apply power to the Load. The Load will be
powered as long as the START button is pressed. Release the
START button to turn off power to the Load.
NOTE: The speaker will beep on and off as long as the START
button is depressed.
the lid)
7-Segment Display Shows:
Model Number
Software version number
Voltage/frequency
Size of tub/up drain
Min-Max water level frequency
Washer serial number
Amana Compact Washer 2-3
n