Setting The Fm Tuning Step; Setting The Am Tuning Step; Switching The Warning Tone; Switching The Auxiliary Setting - Pioneer Super Tuner IIID DEH-P5950IB Operation Manual

Operating this unit
3 Press a or b to set the date and clock.
Pressing a will increase the value of the se-
lected segment. Pressing b will decrease the
value of the selected segment.

Setting the FM tuning step

The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press FUNCTION to select FM STEP.
2 Press c or d to select the FM tuning
step.
Press c to select 50 (50 kHz). Press d to se-
lect 100 (100 kHz).
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.

Setting the AM tuning step

The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
kHz to 1 602 kHz allowable) to 10 kHz (530 kHz
to 1 640 kHz allowable).
1 Press FUNCTION to select AM STEP.
2 Press c or d to select the AM tuning
step.
Press c to select 9 (9 kHz). Press d to select
10 (10 kHz).

Switching the warning tone

If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
Black plate (21,1)
1 Press FUNCTION to select
WARNING TONE.
2 Press a or b to turn WARNING TONE
on or off.

Switching the auxiliary setting

Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 23.
1 Press FUNCTION to select AUX1/AUX2.
2 Press a or b to turn AUX1/AUX2 on or
off.

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can turn the dimmer on or off.
1 Press FUNCTION to select DIMMER.
2 Press a or b to turn DIMMER on or off.
Setting the rear output and
subwoofer controller
This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (REAR SP FULL) or subwoofer
(REAR SP S/W) connection. If you switch the
rear output setting to REAR SP S/W, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
1 Press FUNCTION to select
S/W CONTROL.
<XRD7120-A/N>21
Section
02
21
En