Select Switch Designation; Control Horn And Servo Arm Settings - Horizon Hobby PT-17 Instruction Manual

EN
SAFE ®

Select Switch Designation

®
SAFE Select technology can be easily assigned to any open switch (2 or 3
position) on your transmitter. With this new feature, you now have the fl exibility
to enable or disable the technology while in fl ight.
IMPORTANT: Before assigning your desired switch, ensure that the travel for
that channel is set at 100% in both directions.
Assigning a switch
1. Bind the aircraft correctly to activate SAFE Select. This will allow the
system to be assigned to a switch.
2. Hold both transmitter sticks to the inside bottom corners and toggle the
desired switch 5 times (1 toggle = full up and down) to assign that switch.
The control surfaces of the aircraft will move, indicating the switch has
been selected.
Repeat the process to assign a different switch if desired.
NOTICE: SAFE Select is assignable on any unused Channels 5–9.

Control Horn and Servo Arm Settings

The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR636A
gain values may need to be adjusted. Refer to the Spektrum AR636A manual
for adjustment of gain values.
After fl ying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
8
Mode 1 and 2 Transmitters
3 position Switch
Horns
Elevator
Ailerons
Rudder
More control throw
100%
x 5
100%
2 position Switch
Arms
Less control throw
PT-17