Model Assembly - Horizon Hobby PT-17 Instruction Manual

Model Assembly

Landing Gear Installation
1. Install the landing gear assembly (A) into the pocket located at the bottom
of the fuselage as shown.
2. Secure the landing gear into place with the 4 included screws (B)
(2 x 10mm self-tapping countersunk screws) as shown.
Disassemble in reverse order.
Horizontal Tail Installation
1. Slide the horizontal tail (A) and joiner (B) into the slot in the rear of the
fuselage. Ensure the control horn faces down.
2. Secure the horizontal tail piece in place using the included 2 screws (C).
Use caution to avoid over-tightening the screw.
3. Attach the ball link to the elevator control horn using the included screw and
nut (see instructions for clevis connection).
Tip: Use needle-nose pliers or ball link pliers (RV01005) to remove or install a
link on a control horn
B B
B
2 x 10mm
EN
A
A
B
C
3 x 14mm
countersunk
machine screw
5