Table of Contents
Advertisement
SAFETY INFORMATION
GUIDELINES FOR USING EXTENSION CORDS
USE THE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will
cause overheating. The table below shows the correct size to use depending on cord length and nameplate ampere
rating. If in doubt, use the next heavier gauge.The smaller the gauge number, the heavier the cord.
Ampere Rating
More Than
0
6
10
12
Make sure your extension cord is properly wired and in good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it. Keep your extension cords away from sharp
objects, excessive heat and damp or wet areas.
Use a separate electrical circuit for your tools. This circuit should not be less than #12 wire and should be protected
with a 15 A time delayed fuse. Before connecting the motor to the power line, make sure the switch is in the OFF
position and the electric current is rated the same as the current stamped on the motor nameplate. Running at a
lower voltage will damage the motor.
WARNING:
ALTHOUGH THIS TOOL IS DOUBLE INSULATED, THE EXTENSION CORD AND RECEPTACLE MUST
STILL BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM ELECTRICAL SHOCK.
Minimum Gauge for Extension Cords (AWG)
(when using 120 V only)
Not More Than
6
10
12
16
Total Length of Cord in Feet (meters)
25' (7.6 m)
50' (15 m)
18
16
18
16
16
16
14
12
5
100' (30.4 m)
150' (45.7 m)
16
14
14
Not Recommended
14
12
12
Advertisement
Table of Contents
