Summary of Contents for Yard Works 267-4920
- Page 1 OPERATOR’S MANUAL 13” ELECTRIC HEDGE TRIMMER Item No. 267- 4920 IMPORTANT: Read safety rules and instructions carefully before operating equipment. For parts or service, please call toll free helpline at 1-888-266-7096...
-
Page 2: Table Of Contents
Know your hedger trimmer............................7 Operation................................8-10 Maintenance................................11 Warranty..................................12 Parts List..................................13 PRODUCT SPECIFICATIONS HEDGE TRIMMER ITEM NUMBER..............................267-4920 MODEL NUMBER..............................21098 MOTOR..........................120V AC, 60 Hz, 2.2 AMP RECIPROCATING SPEED...........................3,200 SPM POWER CORD......................14” (35.6 cm), 2-prong polarized BLADE LENGTH............................13” (33 cm) OVERALL TRIMMER LENGTH......................28.5” (72.4 cm) -
Page 3: Safety Information
SAFETY INFORMATION Safety is a combination of common sense, staying alert, and knowing how to use your hedge trimmer. WARNING: TO AVOID MISTAKES THAT COULD CAUSE SERIOUS INJURY, DO NOT PLUG IN THE HEDGE TRIMMER UNTIL THE FOLLOWING STEPS HAVE BEEN READ AND UNDERSTOOD. 1. - Page 4 SAFETY INFORMATION WARNING: TO AVOID ELECTRICAL HAZARDS, FIRE HAZARDS, OR DAMAGE TO THE TOOL, USE PROPER CIRCUIT PROTECTION. YOUR HEDGE TRIMMER IS WIRED AT THE FACTORY FOR 120 V OPERATION. CON- NECT TO A 120 V, 15 A CIRCUIT AND USE A 15 A TIME DELAYED FUSE OR CIRCUIT BREAKER. TO AVOID SHOCK OR FIRE WHEN THE POWER CORD IS WORN, CUT, OR DAMAGED IN ANY WAY, REPLACE IT IMMEDIATELY.
-
Page 5: Safety Information
SAFETY INFORMATION GUIDELINES FOR USING EXTENSION CORDS USE THE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause overheating. -
Page 6: Specific Safety Rules
SPECIFIC SAFETY RULES FOR HEDGE TRIMMER 1. IF YOU ARE NOT thoroughly familiar with the operation of the hedge trimmer, obtain advice from aqualified person. 2. MAKE SURE wiring codes and recommended electrical connections are followed. The hedge trimmer is double insulated. -
Page 7: Know Your Hedger Trimmer
KNOW YOUR HEDGE TRIMMER UNPACKING (Fig. 1) Remove the hedge trimmer from the carton and examine carefully. The hedge trimmer does not require assembly before use. NOTE: Do not discard box or any packing material until all parts are examined. Fig. -
Page 8: Operation
OPERATION WARNING: DO NOT GRASP THE EXPOSED CUTTING BLADES OR CUTTING EDGES WHEN PICKING UP OR HOLD- ING THE HEDGE TRIMMER. WARNING: BEFORE CONNECTING YOUR HEDGE TRIMMER TO THE POWER OUTLET, ALWAYS TURN THE SWITCH TO THE OFF POSITION. FAILURE TO CHECK COULD RESULT IN ACCIDENTAL START–UP CAUSING SERIOUS INJURY. -
Page 9: Trimming Tips
OPERATION TRIMMING TIPS WARNING: TO AVOID INJURY, DO NOT CARRY THE TRIMMER WITH YOUR FINGER ON THE SWITCH. AVOID UNINTENTIONAL STARTING. Before Trimming • IMPORTANT! Lubricate the blade with light machine oil. Ignoring this step and omitting blade lubrication will decrease blade life and cause difficult operation. -
Page 10: Operation
OPERATION To help keep the hedge uniform andhealthy (Fig. 4) • Always trim the hedge so the branches are exposed to the air, sun, and adequate moisture. • Trim the top slightly narrower than the bottom, or trim the sides straight up. •... -
Page 11: Maintenance
MAINTENANCE WARNING: ALWAYS TURN OFF THE TOOL AND UNPLUG THE POWER CORD FROM THE OUTLET BEFORE MAIN- TAINING THE HEDGE TRIMMER. GENERAL MAINTENANCE Keep your hedge trimmer clean and in good repair for maximum performanceand machine longevity. Before each use: •... -
Page 12: Warranty
LIMITED TWO-YEAR WARRANTY The manufacturer warrants to the original purchaser that each new product and service part is free from defects in material and workmanship and agrees to repair or replace under this warranty any defective product or part as follows from the original date of purchase. -
Page 13: Parts List
PARTS LIST Item No. Part No. Description Right housing 3130123 3340287 Self-lock spring Switch button 3410223-2 Switch board 3410123-2 Switch 3630129 Power cord assy. 3110423 Cord board 3410801 Screw 3220345 Switch board spring 3330423-1 Screw 3220313 Left housing 3130123 Screw 3220223 Motor 3610323...