Setting The Clock - Mars RG09D/BGEU Remote Control Manual

Setting the clock

AUTO
CLOCK SET TEMP.
FAN SPEED
1
CLOCK
CAUTIONS
Static electricity or other factors (in case of extremely high voltage) can
cause remote controller clock initialize. If your remote controller is
initialized (flashing "12:00"), readjust the clock before you start operation.
Remote Control Manual - PS-81B / PS-101B
Before you start operating the air conditioner,
set the clock of the remote controller using
the procedures given in this section. The
clock panel on the remote controller will
display the time regardless of whether the
air conditioner is in use or not.
Initial Setting of the Clock
After batteries are inserted in the remote
controller, the clock panel will display "12:00".
Press and hold the CLOCK button for 3nds,
the time begin to flash.
.
1. TEMP/TIME adjust button
Press this button to set time.
Forward.
.
Backward.
2
Each time you press the button, the time
moves forward or backward by one minute
depending on which side you press.
The time alters as quickly as you push the
.
button.
Keep pressing the button without releasing,
the time moves forward or backward by 10
minutes depending on which side you press.
CLOCK button
2.
When the right time is achieved, press the
CLOCK button or release the
wait for 5 seconds, the clock time stops
flashing and the clock starts operating.
3.Readjusting the Clock
Press the CLOCK button on the remote
controller for about 3 seconds, the clock
display time will start to flash.
To set the new time, follow 1 and 2 of "Initial
Setting of the Clock".
Note: The time of the CLOCK must be set
before the AUTO-TIMER feature will operate.
If you readjust the time of the CLOCK after
setting the AUTO-ON/OFF timer, the remote
controller will send the readjusted timer
information to the unit.
* Clock accuracy is within 15 seconds per day.
5
5
or and
Automat
F
1
2