Table of Contents
Advertisement
Installation Checklist
Installation Checklist
GET READY
☛
Note
It is recommended that you wear a grounded wrist
strap when working with hardware installation
procedures.
1. ____ Power off your computer system.
2. ____ Decide which available PCI slot will be used.
3. ____ Remove the plate from the I/O access port to the PCI slot.
4. ____ Remove the AcceleRAID 352 controller from the anti-static bag.
GET SET
5. ____ Plug the AcceleRAID 352 controller into a standard PCI slot
(PCI 2.1 or 2.2 compliant--if using hotplug feature, must be 2.2).
6. ____ Tighten the AcceleRAID 352 controller into the mounting
bracket.
7. ____ Connect the SCSI cable(s) from your drive(s) and/or device(s) to
the desired SCSI channel.
8. ____ Check SCSI termination for internal and/or external devices.
9. ____ Check disk drives. Be sure termination is set to the disabled
position on any disk drive(s) that will not be terminated. For more
information, see the documentation that accompanied the disk
drives.
10. ____ Set SCSI ID on the disk drive(s).
11. ____ Enable termination power on disk drive(s).
12. ____ Safety check the installation.
☛
Note
Review Figure 2-1 and Table 2-5 to get familiar with
the layout of the AcceleRAID 352 controller and the
Connectors, Jumpers, and LED descriptions.
GO
13. ____ Go to Chapter 3, Controller Start-up.
2-4
AcceleRAID 352 Installation Guide
Advertisement
Table of Contents
