Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Installation Manual
Advertisement
Table of Contents
Related Manuals for Mylex DAC960PG
Summary of Contents for Mylex DAC960PG
-
Page 3: Raid Controllers
08P4084 © Copyright 2000 Mylex Corporation. All Rights Reserved. All contents of this manual are copyrighted by Mylex Corporation. The information contained herein is the exclusive property of Mylex Corporation and shall not be copied, transferred, photocopied, translated on paper, film, electronic media, or computer-readable form;... - Page 4 (even if Mylex Corporation has been advised of the possibility of such damages). Any questions or comments regarding this document or its contents should be addressed to Mylex Corporation at the address shown on the cover.
-
Page 5: Regulatory Information
The DAC960PG and DAC960PJ comply with the following regulatory agencies: Federal Communications Commission The FCC information statements are in Appendix E of the DAC960PG and DAC960PJ Installation Guide. Community of Europe The CE information statements are in Appendix E of the DAC960PG and DAC960PJ Installation Guide. - Page 6 Table of Contents Hardware Installation Introduction ................... 1 Performing an Installation ..............1 Connectors, Jumpers ..............2 Installing the DAC960 into the System ..........3 What to Do Next ..................5 Manual No. 775034...
-
Page 7: Hardware Installation
Hardware Installation Introduction The DAC960PG and DAC960PJ are versatile PCI to Ultra SCSI RAID controllers. This quick installation guide assumes that the user is familiar with controller, disk drive, and RAID terminology. Performing an Installation WARNING To avoid electrical shock, do not attempt to perform this hardware installation with power on. -
Page 8: Connectors And Jumpers
Figure 1. All the jumpers should normally be set to their default settings. See Table 1 for default jumper settings. Jumper locations are shown in Figure 1. Figure 1. DAC960PG/PJ with Component Locations Table 1. Jumper and Connector Descriptions Jumper... - Page 9 Contents Installing the DAC960PG or DAC960PJ into the System 1. With the power off, plug the DAC960PG or DAC960PJ controller into an available PCI slot (see Figure 2). System Board Plug Controller into any Available PCI Slot Figure 2. Plugging the DAC960PG or DAC960PJ into a PCI Slot 2.
- Page 10 Figure 3. Connecting Internal and External Drives 8. Connect a wide, round, 68-pin Very High Density Connector Interface (VHDCI) cable to the external SCSI connector on the DAC960PG or DAC960PJ controller, and connect the other end of the cable to an external drive cabinet as required (see Figure 3).
-
Page 11: What To Do Next
Figure 4 shows a completed, typical installation of the DAC960PG or DAC960PJ controller. System Board Figure 4. DAC960PG or DAC960PJ in a Typical Installation The hardware portion of the installation is complete. - Page 12 DAC960PG DAC960PJ Quick Installation Guide...