Cadillac CT6 CUE 2017 Manual page 39

38 REAR SEAT INFOTAINMENT
is off or if the headphones are out of
range of the transmitters for more
than three minutes. Moving too far
forward or stepping out of the vehicle
can cause the headphones to lose the
signal or have static.
Use the volume control wheel on the
right side of the headphones to adjust
the volume.
For best audio performance, wear the
headphones as indicated with L (Left)
and R (Right) on the ear pads. Do not
let anything cover the ear pads.
Caution
Do not store the headphones in
heat or direct sunlight. This could
damage the headphones and repairs
would not be covered by the vehicle
warranty. Storage in extreme cold
can weaken the batteries. Keep the
headphones stored in a cool, dry
place.
If the foam ear pads become worn or
damaged, the pads can be replaced
separately. To purchase replacement
ear pads contact your dealer.
Battery Replacement
To change the batteries:
1. Loosen the screw to the battery
door on the left side of the
headphones using a coin or
flat-head screwdriver.
2. Slide the battery door open.
3. Replace the two AAA batteries.
4. Replace the battery door and
tighten the screw.
Remove the batteries if the
headphones will not be used for a
long time.
Rear Seat Infotainment (RSI)
Wi-Fi (If Equipped)
The RSI Wi-Fi allows the user to
access music, videos and pictures that
are saved or taken with a smart device
to the RSI system through Digital
Living Network Alliance (DLNA)
applications. Only one smart device
can be connected to the RSI at a time.
Placement for Optimal Performance
The RSI Wi-Fi aerial is near the RSI
disc player. The smart device
connection is stronger when it is near
the Wi-Fi aerial.
If the network is not operating at its
maximum effectiveness, try the
following:
Disconnect the smart device from
any other connected network to
improve the audio/video
performance.
Switch the band. While in any
Wi-Fi screen, select Menu, then
select Switch Band to access a
band that is available. Some
marketing regions will only
support a single band.
Digital Living Network Alliance
(DLNA) (If Equipped)
To establish an initial connection:
1. From the RSI Wireless Display
menu, select DLNA. The RSI
screen will display a Wi-Fi
network name, such as