Setting The Cutting Depth; Cord Routing / Cord Restraint; Operation Of The Lawn Edger - Gardenline 50752 User Manual

Understanding and using these operating instructions

Setting the Cutting Depth

The cutting depth of the edger can be altered to
one of 3 settings to a Max of 38mm. (25mm,
31mm, 38mm)
1. To adjust the cutting depth, loosen the height
adjustment knob (21) approx 5–6 full turns, but
do not remove it from the screw. (Fig L)
2. Push the height adjustment knob (21) fully
towards the body of the edger whilst at the
same time pushing the guide wheel (22) arm
in the same direction towards the blade guard
(14). (Fig M)
3. Raise or lower the arm to the desired cutting
depth by aligning the notch on the radial arm
with one of the 3 cutting depth holes (Fig N),
and then pull the height adjusting knob (21)
outwards to secure the the chosen cutting
depth. (Fig O)
4. Tighten the knob until all of the slack is taken
out of the assembly. Check to ensure the guide
wheel arm has located into one of the pre
allocated cutting depth positions and the head
of the bolt securing the front wheel arm is sitting
flat on the surface of the wheel arm.
Firmly tighten the height adjustment knob (21).
(Fig L)
16
e-mail: help@powertoolsupport.com
MODEL: №. 50752 • 08/2017 • 50752
1200W Lawn Edger
L.
LOOSEN
TIGHTEN
M.
N.
O.
AFTER SALES SUPPORT
1800 909 909
(toll free)
1200W Lawn Edger
Cord routing
Always make sure that you route the cord away
from the work area to prevent it from coming near
the blade of the edger. Lay your cable route before
starting work.
Start your edger at the point nearest to the
electrical socket, and then move away whilst
working. This will mean that the cord will be
pulled through the area that has already been cut,
thereby keeping it out of danger of being cut through by the blade.
Cord Restraint
This edger is fitted with a cord restraint to prevent the power cable from
both being disconnected and also to prevent excessive strain on the
connecting plugs during use.
It is recommended the cord restraint is used as follows:
1. Approx 300mm from the end of the extension cable, form a tight loop in
the extension cable, and feed the loop through the hole above the cord
restraint hook (4).
2. Secure the loop over the cord restraint hook (4)
to prevent the cable pulling back through the
hole. (Fig P)

Operation of the Lawn Edger

Switching On and Off
This lawn edger is fitted with a lock off button to
prevent accidental operation.
1. To start the edger, push in the side safety lock
button (3) and then depress the trigger switch
(2) fully. (Fig Q)
Keep your finger on the trigger switch (2) only
to maintain power to the edger. (Fig R)
2. To stop the edger, release the trigger switch (2).
NOTE: Take care when turning the edger "On"
that the cutter is in a safe position to operate.
AFTER SALES SUPPORT
1800 909 909
(toll free)
Operating instructions and safety notes!
P.
Q.
R.
e-mail: help@powertoolsupport.com
MODEL: №. 50752 • 08/2017 • 50752
17