Tilt Eot Sensor Replacement - Philips VL3000 Service Manual

Tilt EOT Sensor Replacement

VL Part No: 23.9661.1253
Repair/Replacement Procedure
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. At tilt-side leg, remove yoke leg cover by removing four 6-32x3/8" PTB screws.
Step 3. At sensor bracket, remove two 10-32x1/2" PPZ screws and remove bracket.
Step 4. Disconnect wiring from Tilt Encoder PCB.
Step 5. At sensor, remove two 6-32x3/8" PPZ screws and remove sensor from bracket.
Step 6. Replace by performing steps 2 through 5 in reverse order.
Sensor
Sensor
Bracket
02.96 78.001 0 G
M P
AINTENANCE ROCEDURES
Tilt Motor
Assembly
Figure 2-25: VL3000 Tilt EOT Sensor Replacement
: T EOT S
ILT ENSOR
NOTE:
Head not shown for clarity.
Tilt Belt
Spring
2
R
EPLACEMENT
45