Husqvarna QCE8600W User Manual page 55

Problem
The lamp does not operate.
The display shows F111.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
The descaling procedure is
interrupted before it finishes.
The descaling procedure is
interrupted before it finishes.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The cleaning function is in-
terrupted before it finishes.
The cleaning function is in-
terrupted before it finishes.
Possible cause
The lamp is defective.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
There is an electrical fault.
You left the dish in the oven
for too long.
The demo mode is activa-
ted.
There was a power cut.
The function was stopped by
the user.
You did not fill the water
drawer to the maximum lev-
el.
The grill- / roasting pan is on
a wrong shelf position.
There was a power cut.
The function was stopped by
the user.
ENGLISH
Remedy
Replace the lamp.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Refer to "Basic Settings" in
"Daily use" chapter.
Repeat the procedure.
Repeat the procedure.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roasting
pan on the first shelf posi-
tion.
Repeat the procedure.
Repeat the procedure.
55