Download  Print this page

Steam Cleaning; Cleaning Reminder - Husqvarna QCE8600W User Manual

Hide thumbs


Table of Contents

12.4 Steam Cleaning

Remove as much dirt as possible
Remove the accessories and the shelf
support to clean the side walls.
The steam cleaning functions support
the steam cavity cleaning of the
For a better performance
you should start the cleaning
function when the appliance
is cool.
The specified time is related
to the duration of the
function and does not
include the time required for
cleaning of the cavity by the
When the steam cleaning function is
active, the light is off.
1. Fill the water drawer to the maximum
level (around 950 ml of water) until
the acoustic signal sounds or the
display shows the message.
2. Choose the steam cleaning function
in the menu: Cleaning.
Steam Cleaning - the duration of the
function is around 30 minutes.
a) Activate the function.
b) An acoustic signal sounds when
the programme is completed.
c) Touch a sensor field to
deactivate the signal.
Steam Cleaning Plus - the duration
of the function is around 75 minutes.
a) Spray a suitable detergent
uniformly in the oven cavity on
both enamel and steel parts.
Before you start the cleaning
procedure, make sure that the
appliance is cold.
b) Activate the function.
After around 50 minutes an
acoustic signal sounds when the
first part of the programme is
c) Press
This is not the end of
the cleaning
procedure. Follow
the message in the
display to complete
the cleaning.
d) Wipe the internal surface of the
appliance with a non-abrasive
surface care sponge. You can use
warm water or oven detergents
to clean the cavity.
e) Press
The final part of the procedure
starts. The duration of this stage
is around 25 minutes.
3. Wipe the internal surface of the
appliance with a non-abrasive
sponge. You can use warm water to
clean the cavity.
After cleaning keep the appliance door
open for approximately 1 hour. Wait until
the appliance is dry. To speed up the
drying you can heat up the appliance
with hot air at temperature 150 °C for
approximately 15 minutes. You can get
maximum effects of the cleaning function
if you manually clean the appliance
immediately after the function ends.

12.5 Cleaning Reminder

When reminder is displayed cleaning is
necessary. Perform the function Steam
Cleaning Plus.
You can enable / disable the function:
Cleaning Reminder in the menu: Basic
12.6 Steam generation system
- Descaling
When the steam generator operates,
limestone accumulates inside it (because
of calcium contents in the water). This
can have a negative effect on the steam
quality, on the performance of the steam
generator and on the food quality. To
prevent limestone accumulation, clean
the steam generation circuit.
Remove all accessories.
Select the function from the menu:
Cleaning. The user interface will guide
you through the procedure.


Table of Contents

  Related Manuals for Husqvarna QCE8600W

This manual is also suitable for: