Troubleshooting - Husqvarna QCE8600W User Manual

54 www.husqvarna-electrolux.se
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The top lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or oper-
ate the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
4. Attach the metal ring to the glass
cover.
5. Install the glass cover.
The side lamp
1. Remove the left shelf support to get
access to the lamp.
2. Use a Torx 20 screwdriver to remove
the cover.
3. Remove and clean the metal frame
and the seal.
4. Replace the lamp with a suitable 300
°C heat-resistant lamp.
5. Install the metal frame and the seal.
Tighten the screws.
6. Install the left shelf support.
Possible cause
The oven is not connected
to an electrical supply or it is
connected incorrectly.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The automatic switch-off is
activated.
The Child Lock is on.
The door is not closed cor-
rectly.
The fuse is blown.
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connec-
tion diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Fully close the door.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.