Advertisement
2. Calculate amount of mixed solution needed for the area to be
treated.
3. Attach inlet / fill hose to spigot or faucet using the vacuum
break / backflow prevent with screen.
NOTE: If the spigot or hose you are using already has a vacuum
break / backflow prevent it is best to remove one of them to allow
sufficient flow. It is recommended to remove the vacuum break /
®
backflow prevent from the inlet / fill hose of the Actisol
Perimeter Pro.
4. Turn on water at spigot or hose.
5. Turn the blue valve on the inlet gap fill assembly to the inline
position to allow flow into the tank.
NOTE: Flow will not pass the blue valve on the inlet gap fill
assembly above the tank until valve is turned to the inline position.
The inlet flow of the water comes from the top of the tank and will
assist in the mixing of the product with the water.
6. Be sure to replace the vacuum break / backflow prevent
immediately when flow has been terminated and inlet / fill hose
has been disconnected from spigot.
NOTE: To recirculate or mix solution, remove lid on tank and
point wand into opening and squeeze trigger to full pin stream.
Page 4
Advertisement
