When Installing The Antenna Inside The Vehicle (On The Dashboard Or Rear Shelf); Installing The Microphone; Parts Supplied; Mounting On The Sun Visor - Pioneer AVIC-5201NEX Operation Manual

Multimedia navigation receiver
Hide thumbs Also See for AVIC-5201NEX:
Table of Contents

Advertisement

When installing the antenna inside the vehicle
(on the dashboard or rear shelf)
WARNING
Do not install the GPS antenna over any sensors or vents on the dashboard of the vehicle,
as doing so may interfere with the proper functioning of such sensors or vents and may
compromise the ability of the metal sheet under the GPS antenna to properly and securely affix
to the dashboard.
GPS antenna
A
Metal sheet
B
Peel off the protective sheet on the rear.
Double-sided tape
C
Clamps|
D
Use clamps to secure the lead where necessary inside the vehicle.
Affix the metal sheet on the surface as level as possible where the GPS antenna faces the window.
Affix the GPS antenna on the metal sheet using the double-sided tape.
NOTES
• The metal sheet contains a strong adhesive which may leave a mark on the surface if it is removed.
• When attaching the metal sheet, do not cut it into small pieces.
• Some models use window glass that does not allow signals from GPS satellites to pass through. On
such models, install the GPS antenna on the outside of the vehicle.
14
En
1
2
3
Make sure the surface
is free of moisture, dust,
grime, oil, etc., before
affixing the metal sheet.
4
Installing the
microphone
• Install the microphone in a place where
its direction and distance from the
driver make it easiest to pick up the
driver's voice.
• Be sure to turn off (ACC OFF) the
product before connecting the
microphone.
• Depending on the vehicle model, the
microphone cable length may be too
short when you mount the microphone
on the sun visor. In such cases, install
the microphone on the steering
column.

Parts supplied

Microphone
Double-sided tape

Mounting on the sun visor

1
Fit the microphone lead into the
groove.
1
2
Microphone lead
A
Groove
B
2
Attach the microphone clip to the
sun visor.
1
2
Microphone clip
A
Microphone clip
B
Use separately sold clamps to secure the
lead where necessary inside the vehicle.
Install the microphone on the sun visor
when it is in the up position. It cannot
recognize the driver's voice if the sun
visor is in the down position.

Installation on the steering column

1
Detach the microphone base from
the microphone clip by sliding the
microphone base while pressing the
tab.
1
2
4
3

Advertisement

Table of Contents
loading

Table of Contents