Restoring All The Settings To The Factory Default Settings - Pioneer BONUS VIEW BDP-51FD Operating Instructions Manual

3 Select the terminal for outputting video signals.
Use / to select, then press .
When a digital output is selected for the video output terminal,
Video is fixed at HDMI and cannot be changed.
When an analog output is selected for the video output terminal,
Component Video or S-Video/Video can be selected for Video.
TOP MENU
HOME
MENU
Initial Setup
BD PLAYER
Video Out Output Terminal Priority
Audio Out
Video
Speakers
HDMI
Audio
Language
Parental Lock
Options
Setup Navigator
• HDMI – HDMI OUT terminal
• Component Video – COMPONENT VIDEO output terminals
• S-Video/Video – S-VIDEO output terminal or VIDEO output
terminal
The video and audio signals output from the set output terminals are
output synchronously (lip synchronization).
4 Select the terminal for outputting audio signals.
Use / to select, then press ENTER.
• HDMI – HDMI OUT terminal
• Digital Audio – DIGITAL OUT terminal (COAXIAL/OPTICAL)
• Analog Audio – AUDIO OUT (2 ch) terminals or AUDIO OUT
(7.1 ch) terminals
The optimum audio signals for the audio format and the player's
settings are output from the output terminal(s) set here.
Caution
• If the output terminal you want to select at Video is not
displayed, use the VIDEO SELECT button to switch between
digital and analog output (page 24).
• When S-Video/Video or Component Video is selected at
Video, no sound will be output if HDMI is selected at Audio (the
warning message shown below is displayed). When listening to
the audio by the HDMI-compatible device, connect to the TV
with the HDMI cable to watch the video (pages 14 and 17).
Audio is not output from HDMI
terminal when [S-Video/Video] or
[Component Video] is selected.
OK to select this setting?
• Linear PCM (2-channel) audio signals are output from the audio
terminals other than the one set at Audio, regardless of the
audio format and the player's settings.
TOOLS
ENTER
RETURN
S-Video/Video
Analog Audio
Yes No
Restoring all the settings to the
factory default settings
1 Check that the player's power is turned on.
When a disc is playing, press  to stop playback.
2
Eject the disc from the player.
3 While pressing , press  STANDBY/ON.
Operate using the buttons on the player's front panel.
Note
• After restoring all the settings to the factory default settings, use
Setup Navigator to reset the player (page 20).
06
49
En