Fluke 1732 User Manual page 42

1732/1734
Users Manual
Options to configure the logging session:
•
Duration and manual start
•
Duration and set start date/time
•
Set start date/time and set end date/time
A memory gauge shows the memory used by recorded sessions and
stored screenshots in black. The memory required for the new session
is shown in green. When the new logging session will not fit in the
available memory, the gauge turns from green to red. If you confirm
the selection, the Logger will adjust the averaging interval accordingly.
Interval of the average calculation
Select the time interval when a new average value is added to the
logging session. The available intervals are: 1 s, 5 s, 10 s, 30 s, 1 min,
5 min, 10 min, 15 min, 30 min.
A shorter interval provides more details at the cost of higher memory
consumption.
Examples of when a short interval is useful:
•
Identify duty cycle of frequently switching loads
•
Energy cost calculation of production steps
36
The Logger recommends an interval based on the duration to get the
best balance between resolution and data size.
A memory gauge shows the memory used by recorded sessions and
stored screenshots in black. The memory required for the new session
is shown in green. In the case where the new logging session will not
fit in the available memory, the gauge turns from green to red. It is still
possible to confirm the selection but the Logger will adjust the duration
accordingly.
Demand Interval
Electrical suppliers use this interval to measure the customer demand.
Select an interval to get energy costs and the maximum demand
value (average power measured over a demand interval).
A value of 15 minutes is normal. If you don't know the average
interval, select 5 minutes. You can recalculate other interval lengths
offline using the Energy Analyze Plus software.
This value is not available for load studies.
Note