Table of Contents
Advertisement
Choosing aperture and shutter speed ( Manual mode)
M mode is a shooting mode where you choose both the aperture value and shutter
speed. Bulb, time, and live composite photography are also available. Rotate the mode
dial to M, and then use the front dial to select aperture value and the rear dial to select
shutter speed.
2
• The exposure determined by the aperture value and shutter speed you have set and
the difference from the suitable exposure measured by the camera are displayed on the
monitor.
• Shutter speed can be set to values between 1/4000 and 60 seconds or to [BULB], [LIVE
TIME], or [LIVECOMP].
• The brightness of the image displayed in the monitor (or viewfi nder) will change with
changes in aperture and shutter speed. You can fi x the brightness of the display so that
you can keep the subject in view while shooting. g [Live View Boost] (P. 110)
• Even when you have set [Noise Reduct.], noise and/or light spots may still be noticeable
in the image displayed on the monitor and shot images under certain environmental
conditions (temperature etc.) and camera settings.
Noise in images
While shooting at slow shutter speeds, noise may appear on screen. These phenomena
occur when the temperature rises in the image pickup device or image pickup device
internal drive circuit, causing current to be generated in those sections of the image pickup
device that are not normally exposed to light. This can also occur when shooting with a
high ISO setting in a high-temperature environment. To reduce this noise, the camera
activates the noise reduction function. g [Noise Reduct.] (P. 111)
48 EN
Wi-Fi
S-IS ON
S-IS ON
M
2.0
2.0
250 F5.6
250
+
+
Difference from correct exposure
ISO-A
200
L
N
FHD
F
30p
1:02:03
1023
Advertisement
Table of Contents
