Charging And Recharging The Batteries - VTech InnoTab3 User Manual

Case: 1:15-cv-10889 Document #: 73-1 Filed: 05/18/16 Page 9 of 41 PageID #:926

Charging and Recharging the Batteries

The rechargeable batteries should be fully charged before the first use. To
charge and recharge the batteries, please follow the instructions below.
1. Make sure the battery packs are installed in the tablet.
2. Use the AC adapter that comes with the InnoTab
AC adapter into the power jack on the InnoTab
end into a wall outlet.
Note: The AC adapter is not a toy, and should only be used by an adult.
3. You can continue to use the InnoTab
connected, but the batteries will not charge while the InnoTab
on. When you're done playing, turn the power off and leave the tablet
connected to a wall outlet to charge it.
4. The green light on the tablet will flash to indicate charging is in progress.
When the batteries are fully charged the light will turn off. A full charge
takes about 4.5 hours with the AC adapter.
Note: If the green light on the tablet flashes very quickly during charging,
the battery packs may not be connected properly. Please reinstall
the battery packs and try again.
Important Notes:
InnoTab
If the tablet is not charging properly, please move it to a location with a
suitable temperature.
the battery packs clean for optimal performance.
before cleaning.
Warning: Do not allow any metal objects to touch the metal contacts on
the battery packs or the contact pins on the InnoTab
5 5
® 3 is turned off before charging.
InnoTab
®
3. Plug one end of the
®
3 and plug the other
®
3 while the AC adapter is
°C~35°C (41°F~95°F).
® 3 and the metal contacts on
®
3 is
®
3.