Focus Assist - Panasonic AG-UMR20P Operating Instructions Manual

Focus Assist

A color is displayed on the part that is focused when Focus Assist is used. (Peaking display)
≥ Switch to Manual Focus Mode.
Press the button while pressing and holding the SHIFT
button.
≥ Press again to cancel.
: Peaking
A
∫ To change the peaking settings
You can set the peaking color and strength.
(When changing the peaking color)
Select the menu.
: [DISP SETUP] # [PEAKING COLOR] # desired color
[Red]/[Blue]/[Yellow]/[White]
(When setting the peaking strength)
1 Select the menu.
: [DISP SETUP] # [PEAKING LEVEL] # desired setting
2 Touch / to adjust settings.
≥ You can select a value between s7 and r7.
3 Touch [EXIT] to complete the setting.
≥ Focus Assist can also be used by pressing the USER button assigned as <FA>.
≥ Focus Assist is not possible in following cases:
j During Recording Check
j During Freeze Frame
j When color bars are displayed
≥ Focus Assist is canceled in following cases:
j If you turn the unit off
j When you set this unit to Auto Focus
≥ The peaking display is not displayed on the image that is actually recorded.
≥ The peaking display is not displayed on the external monitor.
≥ Freeze Frame is not available when you use Focus Assist.
≥ Peaking may not be displayed when you use Digital Zoom
(l 48)
(l 71)
(l 69)
(l 73)
(l 69)
(l 68).
- 51 -
(l 65)
