JVC UX-P400 Service Manual page 23

3.2.4 Removing the CD pickup
(See Figs.7 to 9)
• Remove the traverse mechanism assembly.
(1) From the top side of the traverse mechanism assembly, re-
move the screw D attaching the shaft holder. (See Fig.7)
(2) Release the joint h and take out the shaft holder. (See
Fig.7)
(3) Remove the two screws E attaching the rack arm and take
out the rack arm. (See Fig.8)
(4) Remove the feed middle gear and remove the screw shaft
of the CD pickup from the section i on the traverse mecha-
nism assembly. (See Fig.8)
(5) Remove the CD pickup from the section j of the traverse
mechanism assembly and take out the CD pickup with the
screw shaft. (See fig.8)
(6) Pull the screw shaft out of the CD pickup. (See Fig.8)
(7) From the bottom side of the CD pickup, solder the short
land sections k on the CD pickup. (See Fig.9)
(8) Release the lock of the connector on the CD pickup in the
direction of the arrow and disconnect the card wire. (See
Fig.9)
Caution:
• Solder the short land sections k on the CD pickup before dis-
connecting the card wire from the connector on the CD pick-
up. If the card wire is disconnected without attaching solder,
the CD pickup may be destroyed by static electricity. (See
Fig.9)
• When attaching the CD pickup, be sure to remove solders
from the short land sections k after connecting the card wire
to the connector on the CD pickup. (See Fig.9)
D
Shaft holder
Joint h
Traverse mechanism assembly
Fig.7
Feed middle gear
Screw shaft
CD pickup
Fig.8
Short land section k
CD pickup Connector
Fig.9
Rack arm
E
Section i
Section j
Card wire
(No.MB262)1-23