Hdd Installation - Funlux NVR Quick Start Manual

HDD Installation

1
If your system does not include a pre-installed HDD, you
can purchase your own and follow the steps below for
installation. Make sure you purchase a 3.5" HDD
optimized for always-on read/write surveillance, e.g. low-
power WD10PURX hard drives.
1
Make sure that your NVR is powered off and unplugged
from the power source. Slide the cover off of the NVR.
(Image may vary for your specific NVR model.)
2
Connect the HDD to the NVR using the corresponding
SATA power and data cables. Insert the HDD into the
NVR in the red zone shown below.
(Image may vary for your specific NVR model.)
1