Accurate Technology 150 User Manual page 32

Pr22 – Backlight ON time
The ON time of the LCD backlighting (24VDC Displays only).
0 = always off.
1 = 3 seconds.
2 = 7 seconds.
3 = 15 seconds.
4 = always on.
NOTE: Backlighting is activated when a key is pressed.
Pr 23 Future Use
DO NOT CHANGE
Pr 24 Display RF Address
This parameter is used to set the address of the Display.
0= (RF off)
Pr 25 RF System ID
This parameter is used to set the ID of the Display system (or
family).
Pr 26 Noise Suppresion
This setting helps filter error causing interference caused by stray
electrical noise when the Display is mounted on or around a
machine.
0 = Minimum filtering
7 = Maximum filtering
Pr 27 Accuracy Compensation Enable *
This setting enables the ProScale Display measurement
compensation feature.
0 = Compensation Off
1 = Compensation On
Pr 28 Compensation Multiple *
This value is the length of the measurement standards used for
Accuracy Compensation Calibration.
The default is 5 inches. If some other multiple (length) is used,
change this value to match the multiple (length). i.e. 6".
* Pr27 and Pr28 are operational ONLY on Displays with Firmware versions
ending in "C"
Accurate Technology ProScale
[0, 1, 2, 3 or 4]
[1]
[0 to 63]
[0 to 31]
[0..7]
[0, 1]
[5]
Page 32 of 48