Accurate Technology 150 User Manual page 29

Pr0 – Reading Direction
Change/Reverse the direction (+ vs -) of readings.
Pr1 – Enable/Disable Segment Offset
0 = For ALL Incremental Scales
1 = For All ABSOLUTE Scales
Pr2 – High Speed ReadHead
0 = Normal ReadHead
1 = High Speed ReadHead
Use only if instructed. A setting of 1 will impact battery life.
Pr3 – Enable/Disable the +, - and ZERO keys
0 = Disables operation of Zero, + and – keys (Forced Lock Mode).
1 = Enables operation of Zero, + and – keys.
Pr4 – Display Resolution
Sets the displayed resolution. (No change in fractions mode.)
0 = Reduced resolution
1 = Normal resolution
2 = Increased resolution*
*(Automatic scaling will allow measurements of over 100 inches
when in high resolution. Measurements over 100 inches will
automatically be reduced to 3 decimal places.)
Pr5 – Metric Display Units
Controls whether the measured value is displayed in millimeters or
centimeters when metric mode is selected.
0 = millimeters
1 = centimeters
Pr6 – Disable Fractions/Inches
0 = All measurement modes (mm or cm, inches and fractions).
1 = No Fractions. Only decimal inches and metric units*.
2 = Only Metric. No Imperial (inches or fractions) will be displayed.
* Pr5 will determine if mm or cm are displayed for metric units.
Pr7 – Scaling Factor
The multiplier applied to the measurement. Scaling factors less than
1.0000 will make the displayed measurement less that the actual
measurement. Scaling factors greater than 1.0000 will make the
displayed measurement greater than the actual measurement.
ProScale M150, M250 with LCD Digital Displays
[.0001 .. 99.9999]
[0,1]
[0, 1]
[0, 1]
[0,1]
[0, 1, or 2]
Inch = xxx.xx
Inch = xxx.xxx MM = xx.xx
Inch = xx.xxxx (no change in mm)
[0, 1]
[0, 1, 2]
Default = 1.0000
MM = xx.x
(No Scaling.)
Page 29 of 48