Accurate Technology 150 User Manual page 31

Pr14 – Output Signal Mode
Configures the hardware output signal for activation on MONitor drift
conditions or Upper/Lower limit alarm conditions.
Applies to 24VDC Displays only.
0 = Off
1 = Monitor Drift
2 = Upper/Lower Limit
Pr15 – Output Polarity
Used to configure the signal output.
N/O or N/C in relation to circuit ground.
0 = N/O, the output is Normally Open (not conducting to ground).
1 = N/C, the output is Normally Closed (conducting to ground).
Active only when Pr14=1
Pr16 – Lower Limit
Sets the lower limit alarm value.
Active only when Pr14=2.
Pr17 – Upper Limit
Sets the upper limit alarm value.
Active only when Pr14=2.
Pr18 – Drift Tolerance
Range of motion allowed (+ or -).
while in MONitor mode
Pr19 – Automatic Monitor ON Time
Configures Display to automatically activate MONitor mode after
30 or 60 seconds of ReadHead inactivity.
0 = disabled
1 = 30 seconds
2 = 60 seconds
Pr20 – Automatic Monitor OFF Enable
Configures Display to automatically exit MONitor mode after a
programmed distance (Pr21) has been exceeded from the drift
tolerance position (Pr18).
0 = disabled
1 = enabled
Pr21 – Automatic Monitor OFF Distance
[0.001 to 999.999in] or [0.01 to 9999.99mm].
The distance that must be exceeded from the drift tolerance
position (Pr18) to deactivate monitor mode.
Active only when Pr20=1
ProScale M150, M250 with LCD Digital Displays
[-999.999 to 999.999in] or [-9999.99 to 9999.99mm]
[-999.999 to 999.999in] or [-9999.99 to 9999.99mm]
[.001 to 999.999in] or [.01 to 9999.99mm ]
[0, 1, 2]
SEE Pr15, Pr16, Pr17 ALSO
[0, 1]
Default = 0.000 in.
Default is set in Inches.
Default = 5.000 in.
Default is set in Inches.
Default =. 010 in.
Default is set in Inches
[0, 1 or 2]
[0, 1]
Default = 0.500 in.
Default set in Inches
(0.00mm)
(127.00mm)
(.254mm)
(12.70mm)
Page 31 of 48