Table of Contents
Advertisement
18
4.2
MOUNTING PLATE INSTALLATION
EN
A.
Level and affix the mounting template to the wall at the desired location and height. The centre of the
vent pipe must be centered between wall studs.
B.
Using the template, mark the holes for the vent, gas and electrical outlets, and mounting screw
locations. See "MINIMUM CLEARANCES TO COMBUSTIBLES" section. NOTE : Choose the
appropriate screws required for either combustible or non-combustible material. A minimum of
four screws must be used to mount appliance into wall studs.
C.
Remove the mounting template from the wall and cut/drill the required holes as marked.
D.
Screw the vent shield together using the screws provided (Fig. 1).
E.
Bend the 4 tabs on the firestop spacer outwards. Slide the vent shield into the firestop spacer aligning
the holes within the tabs. Using 4 of the screws provided, secure the vent shield to the firestop spacer
(Fig. 2).
F.
The vent shield and firestop spacer have been designed to accommodate a maximum wall depth of
14" (35.6cm). The vent shield must extend the full depth of the combustible wall. Trim the vent shield
to suit as necessary.
G.
Apply a bead of caulking (not supplied) to the flange perimeter and wings of the firestop spacer. Insert
the firestop spacer with mounted vent shield into the wall and level the firestop spacer. Once leveled,
secure firestop spacer to the wall using 4 fasteners (Fig. 3).
H.
Install mounting plate by aligning dimples on firestop spacer and secure using four screws provided.
(Fig. 4)
WALL
W415-1606 / 09.09.16
CAULKING
REAR VIEW
FIG.1
FIG.3
FIG.2
FIG.4
Advertisement
Table of Contents
