Table of Contents
Advertisement
OPERATION PROCEDURE
This section includes useful information about oven operation.
1. Plug power supply cord into a standard 3-pronged 15 Amp, 230V AC 50Hz power outlet.
2. After placing the food in a suitable container, open the oven door and put it on the glass tray.
The glass tray and roller guide must always be in place during cooking.
3. Shut the door. Make sure that it is firmly closed.
1
The oven light is on when the microwave oven
is operating.
2
The oven door can be open at any time during
operation by pushing the door open button on
the control panel.The oven will automatically
shut off.
3
Each time a pad is touched, a BEEP will sound
to acknowledge the touch.
4
The oven automatically cooks on full power
unless set to a lower power level.
5
The display will show nothing when the oven is
plugged in, press and hold the ZERO ON
button until display is turned on and beep
sounds.
6
"End" is displayed when the cooking time ends.
WATTAGE OUTPUT CHART
• The power-level is set by touching the POWER pad. The chart shows the display, the power level and
the percentage of power.
Touch the POWER pad
once
twice
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times
11 times
7
When the STOP/CLEAR pad is touched during
the oven operation, the oven stops cooking and
all information retained. To erase all information,
touch the STOP/CLEAR pad once more. If the
oven door is opened during the oven operation,
all information is retained.
8
If the START /SPEEDY COOK pad is touched
and the oven does not operate, check the area
between the door and door seal for obstructions
and make sure the door is closed securely. The
oven will not start cooking until the door is
completely closed or the program has been reset.
Make sure the oven is properly installed
and plugged into the electrical outlet.
Power Level (Display)
P-HI
P-90
P-80
P-70
P-60
P-50
P-40
P-30
P-20
P-10
P-00
11
Approximate Percentage of Power
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
0%
Advertisement
Table of Contents
