Removing The Heat Sink; Removing The Rear Panel; Removing The Main Board - JVC KS-FX921 Service Manual

2.1.4 Removing the heat sink

(See Fig.5)
• Prior to performing the following procedure, remove the front
panel assembly.
(1) Remove the two screws C and screw D attaching the heat
sink on the left side of the main body, and remove the heat
sink.

2.1.5 Removing the rear panel

(See Fig.6)
• Prior to performing the following procedure, remove the front
panel assembly and bottom cover.
(1) Remove the two screws E, three screws F and three
screws G attaching the rear panel on the back side of the
main body.

2.1.6 Removing the main board

(See Fig.7)
• Prior to performing the following procedures, remove the front
panel assembly, bottom cover, front chassis assembly, heat
sink and rear panel.
(1) Remove the two screws H attaching the main board on the
top chassis.
(2) Disconnect the connector CP701 on the main board from
the cassette mechanism assembly.
D
Fig.5
F
Rear bracket
E
Fig.6
H
CP701
Fig.7
C
Heat sink
G
E
F
Main board
H
(No.49846)1-5