JVC KD-SHX701 Service Manual page 16

3.2.6 Removing the front unit
(See 10 to 12)
• Prior to performing the following procedures, remove the top
cover and mechanism section.
(1) From the bottom side of the mechanism section, discon-
nect the flexible wire from connector
end board. (See Fig.10)
(2) From the top of the mechanism section, remove the screw
D attaching the front unit. (See Fig.11)
(3) Move the front unit toward the front to release joint i. (See
Fig.11)
(4) Release two joints j and k on the right side of the chassis
base. (See Fig.12)
(5) Take out the front unit upward, and remove the two screws
E attaching the switch wire. (See Fig.12)
Reference:
You can remove the switch wire only without removing the
front unit.
Caution:
When reassembling, attach the flexible wire extending from
the switch wire using a double-stick tape. (See Fig.12)
1-16 (No.MA047)
CN503 on the front-
Fig.10
Front unit
Fig.11
Double-stick tape E
Joint j
Joint k
Chassis base
Fig.12
Front-end
board
Flexible
wire
CN503
D
Joint i
Switch wire
D
Front unit
Joint i