Seiko SMARTCS NS-2250 Instruction Manual page 172

Settings of the NS-2250
set hostname SmartCS
set ipaddr eth1 192.168.1.100/24
create ip route default gateway 192.168.1.254
set sshd auth basic
create allowhost all service portd sshrw all
set portd auth basic
create user user01 group portusr password
(password entry)
create user user02 group portusr password
(password entry)
create user user03 group portusr password
(password entry)
set user user01 port 1-32
set user user02 port 1-32
set user user03 port 1-32
enable sshd
create allowhost all service sshd
set user somebody password
(password entry)
Explanation of settings
1. Set the name of the NS-2250 to the "SmartCS", set the LAN1 P address to
"192.168.1.100/24", and set the default route to "192.168.1.254".
set hostname SmartCS
set ipaddr eth1 192.168.1.100/24
create ip route default gateway 192.168.1.254
2. Set the SSH authentication method to Password (basic) authentication, and then
configure the settings to allow access to all serial ports in SSH Normal mode from all
network addresses.
set sshd auth basic
create allowhost all service portd sshrw all
3. Switch on Port user authentication.
set portd auth basic
4. Create port users (user01 to user03) to use port user authentication.
create user user01 group portusr password
(password entry)
create user user02 group portusr password
(password entry)
create user user03 group portusr password
(password entry)
4-76