Electrical Connection; Ventilation Requirements - AEG SWD81800G1 User Manual

14 www.aeg.com

6.2 Electrical Connection

CAUTION!
Any electrical work required to
install this appliance should be
carried out by a qualified electri-
cian or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any li-
ability should these safety meas-
ures not be observed.
A
E
The wires in the mains lead are
coloured in accordance with the
following code:
A Green and Yellow:

6.3 Ventilation requirements

5 cm
B
C
D
Earth
min.
200 cm
2
min.
200 cm
C Brown:
E Blue:
As the colours of the wires in the mains
lead of this appliance may not corre-
spond with the coloured markings iden-
tifying the terminals in your plug, pro-
ceed as follows:
1. Connect the wire coloured green
and yellow to the terminal marked
either with the letter "E" or by the
earth symbol
and yellow.
2.
Connect the wire coloured blue to
the terminal either marked with the
letter "N" or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
"L" or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp D
is secure over the outer sheath.
5. Make sure the electricity supply volt-
age is the same as that indicated on
the appliance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp
plug fitted B. In the event of having to
change the fuse in the plug supplied, a
13 amp ASTA approved (BS 1362) fuse
must be used.
WARNING!
A cut off plug inserted into a 13
amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
The airflow behind the appliance must
be sufficient.
2
Live
Neutral
or coloured green