Vrrp Load Balancing Configuration Example - HP MSR Series Configuration Manual

VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
The output shows the following information:
Router A is operating as the master in VRRP group 1 to forward Internet traffic for hosts that use the
•
default gateway 1::10/64.
Router B is operating as the master in VRRP group 2 to forward Internet traffic for hosts that use the
•
default gateway 1::20/64.

VRRP load balancing configuration example

Network requirements
As shown in
virtual IPv6 addresses FE80::10 and 1::10 to provide gateway service for the subnet 1::/64.
Hosts on subnet 1::/64 learn 1::10 as their default gateway from RA messages sent by the routers.
Configure VFs on Router A, Router B, or Router C to monitor their respective GigabitEthernet 2/0/2.
When the interface on any of them fails, the weights of the VFs on the problematic router decrease so
another AVF can take over.
Figure 21 Network diagram
: 2
: Up
: 110
: Yes
: None
: FE80::20
1::20
: 0000-5e00-0202
: FE80::2
Figure 21, Router A, Router B, and Router C form a load balanced VRRP group and use the
Adver Timer : 100
State : Master
Running Pri : 110
Delay Time : 0
54