Table of Contents
Advertisement
Page 6
Turning Your Headset On and Off
Turning On the Headset
Press and hold the MFB for 2 seconds until you hear a short beep. The LED will
flash blue.
IMPORTANT Press the MFB again each time you turn on the headset to
reactivate pairing so that the connection between the headset and the mobile
handset is resumed. For pairing, please refer to "Pairing Your Headset" on page
7-8.
Turning Off the Headset
Press and hold the MFB for 3 seconds until you hear a long beep. The LED flash
stops.
IMPORTANT
To disconnect the Bluetooth connection, please firstly turn of
your headset by pressing the MFB key.
Turning the Built-in Buzzer On and Off
Turning On the Built-in Buzzer
Press and hold the Volume + for 2 seconds until you hear a long beep. The LED
flashes blue.
NOTE
The built-in buzzer is set to "ON" when shipped.
Turning off the Built-in Buzzer
Press and hold the Volume – for 2 seconds until you hear 2 short beeps. The LED
flashes red. Now, when there is an incoming call, the ringing tone can be heard
through the earphone only.
Advertisement
Table of Contents
Need help?
Do you have a question about the Clip IIIs and is the answer not in the manual?