1. Manuals
  2. Brands
  3. Roundup Manuals
  4. Kitchen Appliances
  5. STS-200
  6. Owner's manual

Roundup STS-200 Owner's Manual

Steamer/scale
Hide thumbs Also See for STS-200:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual
MaNufactuRiNg
NuMBeRs:
910 0 9 2 2
C
US
CM
P/N 1010929 Rev. B 03/12
Steamer/Scale
Owner
Model STS-200
s manual
'

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STS-200 and is the answer not in the manual?

Questions and answers

Related Manuals for Roundup STS-200

Summary of Contents for Roundup STS-200

  • Page 1 MaNufactuRiNg NuMBeRs: 910 0 9 2 2 Steamer/Scale Model STS-200 P/N 1010929 Rev. B 03/12 Owner s manual ’...

  • Page 2: Table Of Contents

    Rotary switch settings ..........8 Owner InfOrmatIOn General warranty Information the sts-200 steamer/scale produces steam using Please read the full text of the Limited Warranty in this plain tap water for quick steaming of sliced meats. manual. simple push-button action delivers a consistent impulse if the unit arrives damaged, contact the carrier imme- of steam.

  • Page 3: Service/Technical Assistance

    Refer to the service agency directory and fill in the information below: if you experience any problems with the installation or operation of your unit, contact your local Roundup authorized service agency authorized service agency. they can be found in the Name: service agency directory packaged with the equipment.
  • Page 4 • Do NOT clean this appliance with a water jet. • This equipment should be serviced by qualified • Do NOT use a sanitizing solution or abrasive personnel only. contact the nearest Roundup materials. the use of these may cause damage authorized service agency for adjustment or to the stainless steel finish. repair.

  • Page 5: Specifications

    STS-200 STeamer/Scale specIfIcatIOns Dimensions electrical ratings model & 8 1/2" 13 1/2" Voltage watts amps Hertz (216 mm) mfg. no (33 mm) sts-200 1500 12.5 50/60 9100922 7 1/4" (184 mm) electrical cord & plug configurations model & Description configuration mfg.

  • Page 6: Installation

    Hidden button equipment setup Zero (on) button General the sts-200 steamer/scale is used to heat and portion Digital Oz LED air Bulb sliced meats. the air Bulb switch initiates a shot of Display switch steam while the digital display shows the weight of the...

  • Page 7: Operation

    STS-200 STeamer/Scale OperatIOn 6. When the Blue LED turns on, another steam/time cautIOn cycle can be initiated. Handle the steamer/scale with great care. Do not place objects other than sliced meat on the unit 7. Remove steamed product and complete the and neVer place anything over 4 pounds (64 assembly of the sandwich.

  • Page 8: Rotary Switch Settings

    STS-200 STeamer/Scale OperatIOn (continued) rotary switch settings setting temp. cycle/sec shot/sec at the back of the sts-200 unit are three Rotary 375°f* 10.0 switches: temp, cycle, and shot. 370°f 365°f 360°f TEMP CYCLE SHOT 355°f 350°f the temp Rotary switch sets the operating temperature 345°f...

  • Page 9: Maintenance

    3. steamer/scale components warranty. cleaning the sts-200 During Daily use the frequency of cleaning is determined by water con- ditions, usage and water filter systems. cautIOn...

  • Page 10: Daily Maintenance

    Repeat this step as needed until the steam cleaning product labels. generator is cleaned. the sts-200 steamer/scale utilizes an open steam 10. In this step, the cloths are to be damp, nOt generator. Water sprayed into the steam generator dripping wet. clean the steamer scale base...
  • Page 11 7–9 psi. spoon of baking soda with 3 ounces of water. testInG tHe sts-200 fOr weIGHInG accuracy pour the seasoning mixture onto the hot steam 1. turn the unit on and allow it to warm up for 30 Generator.

  • Page 12: Monthly Maintenance

    STS-200 STeamer/Scale maIntenance (continued) monthly maintenance cHecKInG/cleanInG tHe water straIner the Water strainer protects the unit from any foreign debris in the water line that could get into the food, damage the unit’s solenoid (causing the unit to leak or flood), or interfere with the equipment’s proper and...

  • Page 13: Troubleshooting

    STS-200 STeamer/Scale trOublesHOOtInG message codes the table below lists the possible message codes displayed by the unit during operation. contact the factory if you have any questions about these message codes. message Description code Display test, all digits on. Software part number, DSW0093. software revision. r0.3 Loading zero, shown on start up.
  • Page 14 STS-200 STeamer/Scale trOublesHOOtInG (continued) problem possible cause(s) corrective action the unit heats up and steams but faulty scale control Board. contact your maintenance person the front display is blank. or an authorized service agency for faulty temperature control Board. service.
  • Page 15 STS-200 STeamer/Scale trOublesHOOtInG (continued) problem possible cause(s) corrective action scale is not weighing prop- scale requires calibration. calibrate scale according section titled erly and/or behaves “calibrating the steamer scale” in the erratically. Operation section of this manual. interference/binding with the floating if unit was recently disassembled and/or “spider”...
  • Page 16 STS-200 STeamer/Scale trOublesHOOtInG (continued) problem possible cause(s) corrective action the unit is not the Water Pressure Regulator is improp- adjust regulator to 7-9 Psi. Refer to the sec- steaming the product erly set. tion titled “adjusting the Water Pressure properly and/or the Regulator”...

  • Page 17: Technical Theory Of Operation

    Board. cause must be determined and corrected. Once powered, and provided that the generator surface nOte: the sts-200 scale/steamer is shipped with temperature is below 375ºf (190ºc), the multifunctional a dual water pressure regulator assembly. the pri- temperature control Board calls for heat by energizing mary water pressure regulator is fixed at 30 psI its on board mechanical relay.
  • Page 18 STS-200 STeamer/Scale tecHnIcal tHeOry Of OperatIOn (continued) blue lIGHt blInKInG cODes (refer alsO tO tHe leD functIOn trOublesHOOtInG sectIOn) (The following LEDs are viewed from the rear of the rapid flashing: under this condition, the generator unit) may, or may not get hot. the solenoid valve circuit is yellow (Heat): When lit, it indicates that the unit is in disabled until the cause is corrected.

  • Page 19: Replacement Parts

    STS-200 STeamer/Scale replacement parts Page 24 Page 23 Page 22 See Page 20 See Page 21 P/N 1010929 Rev. B 03/12 A.J. Antunes & Co.
  • Page 20 STS-200 STeamer/Scale replacement parts (continued) Item part Description qty. Item part Description qty. 7000682 Generator Elbow Kit (Incl. 3) 7000424 Generator Kit (incl. 2, 4, 5, 7, 8, & 10) 2020117** tube, silicone 0100245** generator Machined 2190168** Barb fitting 1/8” NPt* 7000458 Hi-Limit Thermostat Kit* 4050228** Probe, thermistor 0011787** cartridge Heater assy.
  • Page 21 STS-200 STeamer/Scale replacement parts (continued) Item part Description qty. 308P189 screw 8-32 x 1/4” (10-pack) 310P170** Nut, #10-32 NY-Lock (10-pack) 800P007** screw, M6 x 16 mm Hex Head 0504087** spider 0504122** spacer, Load cell 4030367** Load cell Includes item #5, 3, and 2 310P146** Nut, Hex “KEPS” #10-32 0504082** Plate, Base 310P180** screw, Mach.
  • Page 22 STS-200 STeamer/Scale replacement parts (continued) Item Number Docum Numb 0504057 3060142 0504124 0504125 0100245 4030373 3040114 4030374 4050228 3080192 2100104 2190142 2020117 3060130 0504053 4060386 4070075 21000-000 0504123 0504071 0504072 0400147 4010151 0504088 4070072 3060105 4010212 4040145 4040145-2 4040145-3 4040145-4...
  • Page 23 STS-200 STeamer/Scale replacement parts (continued) NOTE: Item 8 can be purchased separately in kit #7000429 Item part Description qty. Item part Description qty. 20 306P130* Nut, Hex KEPS #6-32 7000425 solenoid assy. (incl. items 2-9) 0504088 Plate, control 4040175** solenoid Valve 22 306P123* Screw, Mach #6-32 x 7/8” Sltrshd 0504089** Plate, solenoid 23 306P105* Screw, Mach #6-32 x 1/2” Sltrshd.
  • Page 24 STS-200 STeamer/Scale replacement parts (continued) Item part Description qty. 0011784 top cover Weldment 304P114 Screw, Machine #4-40 x 1/4” (10 pack) 0504121 seal Retainer 0300145 screw, Locator (peg, steel) 2120157 spacer 2120154 standoff 7000423 Seal Kit, pack of 4 (Incl. #2) 0011776 Diffuser Assembly P/N 1010929 Rev. B 03/12 A.J. Antunes & Co.
  • Page 25 STS-200 STeamer/Scale replacement parts (continued) Dual Water Pressure Regulator Kit (P/N 7000418) Orange O-Ring Strainer Screen Strainer Cup Inlet Tubing NOT Supplied Must use 1/4" I.D Nylon Braided Hose Item part Description qty. Item part Description qty. 7000333 strainer 1/4 ftP (includes O-Ring, 7000139 Elbow, Quick Disconnect strainer screen, and strainer cup (incl 2 &...
  • Page 26 STS-200 STeamer/Scale replacement parts (continued) Item part Description qty. 7000435 Weight 1 lb (16 ounces) (incl 1a) 2130173 Wire Brush P/N 1010929 Rev. B 03/12 A.J. Antunes & Co.

  • Page 27: Wiring Diagram

    STS-200 STeamer/Scale wIrInG DIaGram NOTE: ALL WIRES TO BE 14 GA. TFE-200°C POWER UNLESS OTHERWISE SPECIFIED. ZERO/HIDDEN CORD SWITCH # 16 GA. TFE-200°C 22 GA. TFE-200°C FERRITE CORE TERMINAL BLOCK SCALE CONTROL VARISTORS (X3) LOAD CELL POWER SWITCH AIR SWITCH...

  • Page 28: Limited Warranty

    2 hours (100 miles/160 km) round trip from the nearest authorized service agency. 2. Roundup reserves the right to make changes in design or add any improvements on any product. the right is always reserved to modify equipment because of factors beyond our control and government regulations.

Table of Contents