Advertisement

www.ajantunes.com
PO W ER
ON LY
SU PP LY
W AT ER
US E R. O.
RE AD Y
IN G
ST EA M
C YC LE
ST AR T
CM-100
cheese melter
owner's manual
Manufacturing Numbers:
9100416
9100417
P/N 1011175 Rev. D 09/13

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CM-100 and is the answer not in the manual?

Questions and answers

Summary of Contents for Roundup CM-100

  • Page 1 ON LY SU PP LY W AT ER US E R. O. RE AD Y IN G ST EA M C YC LE ST AR T CM-100 cheese melter owner’s manual Manufacturing Numbers: 9100416 9100417 www.ajantunes.com P/N 1011175 Rev. D 09/13...
  • Page 2: Table Of Contents

    Table of Contents GENERAL SERVICE/TECHNICAL ASSISTANCE The Taco Bell CM-100 Cheese Melter produces General ..........2 steam to quickly heat and melt cheese for a Warranty Information ......2 If you experience any problems with the variety of products. Simple push-button action Service/Technical Assistance ....
  • Page 3: Important Safety Information

    IMPORTANT SAFETY WARNINGS INFORMATION • Do not use a sanitizing solution or Be advised of the following warnings when operating and performing maintenance on abrasive materials. The use of these Use the following guidelines for safe opera- may cause damage to the stainless this unit.
  • Page 4: Specifications

    SPECIFICATIONS R .O U SE Model & Width Depth Height Mfg No. CM-100 17 3/8” 17 5/8” 8 3/8” 9100416 (441 mm) (448 mm) (213 mm) 9100417 Model & Volts Watts Amps Hertz Plug Description Mfg No. CM-100 9100416 3300...
  • Page 5: Installation

    • Do not block or cover any openings on PLUMBING the unit. 1. Remove unit and all packing materials The CM-100 requires installation of a reverse • Do not immerse the power cord or from the shipping carton. osmosis filtration system for supplying water plug in water.
  • Page 6: Operating Instructions

    If the unit continues to shut off due to over- during operation, see the Troubleshooting ing the product is ready to be served. heating, contact your Roundup Authorized section in this manual. 6. Carefully remove the steamed product Service Agency.
  • Page 7: Daily Cleaning

    Turn the power off, unplug the power cord, Liner Steam Ports and allow the unit to cool before performing any service or maintenance. Figure 6. CM-100 Components DAILY CLEANING MONTHLY CLEANING for proper mixture and use. It must be safe for use on aluminum.
  • Page 8: Calibration

    CALIBRATION If the unit does not steam properly and the water pressure is 20–25 psi, use the steps below to calibrate the water volume. 1. With the unit positioned at the edge of its location surface (counter, table, etc.), slide the unit forward approxi- mately 3"...
  • Page 9: Troubleshooting

    TROUBLESHOOTING WARNING To avoid possible personal injury and/or damage to the unit, inspection, test, and repair of electrical equipment should be performed by qualified service personnel. The unit should be unplugged when servicing, except when electrical tests are required. Use extreme care during electrical circuit tests.
  • Page 10 TROUBLESHOOTING (continued) Problem Possible Cause Corrective Action Unit only leaks water when powered Solenoid Valve is leaking due to debris trapped Contact your local Authorized Service Agency. off. within its plunger and seat. NOTE: This condition is not covered by warranty. To prevent debris from entering a solenoid, an in-water strainer must be used.
  • Page 11: Wiring Diagram

    WIRING DIAGRAM P/N 1011175 Rev. D 09/13...
  • Page 12: Replacement Parts

    REPLACEMENT PARTS ITEMS SPECIFIC TO MFG. NO. 9100417 (P/N 0100280) (P/N 0200311) (P/N 3080104) (P/N 0200310) (P/N 0021923) (P/N 0200324) (P/N 0200323) (P/N 3080104) R SU E R. P/N 1011175 Rev. D 09/13...
  • Page 13 REPLACEMENT PARTS (continued) Item Part No. Description Qty. Item Part No. Description Qty. Item Part No. Description Qty. 0506007 Cavity Liner 27 2040103 Male Connector, 57 0505997 Control Housing Cover 1 1/4" x 1/8" NPT (Mfg. No. 9100416) 58 0505998 End Housing Cover 0506687 Cavity Liner 28 2040146 Female Tee Fitting 59 7000136 Terminal Block...
  • Page 14: Notes

    NOTES P/N 1011175 Rev. D 09/13...
  • Page 15 NOTES (continued) P/N 1011175 Rev. D 09/13...
  • Page 16: Limited Warranty

    2. Roundup reserves the right to make changes in design or add any improvements on any product. The right is always reserved to modify equipment because of factors beyond our control and government regulations. Changes to update equipment do not con- stitute a warranty charge.

Table of Contents